Lincoln Electric PIPEFAB Series Operator's Manual page 59

PIPEFAB™ WELDING SYSTEM OPERATION
COLD FEED
Pressing the Cold Feed rocker switch feeds wire forward at the indicated speed for as long as the switch
is held. When connected to the PipeFab™ Remote UI, Cold Feed may be ac�ve by the rocker switch on
the side of the feeder or the rocker switch on the front of the Remote UI.
The power source output remains OFF during Cold Feeding.
To set cold feed speed, turn the le� knob while holding the cold feed bu�on.
FIGURE B.4
GAS PURGE
Pressing the Gas Purge rocker switch turns on the gas solenoid for as long as the gas purge switch is
held. When connected to the PipeFab™ Remote UI, gas purge may be ac�ve by the rocker switch on
the side of the feeder or the rocker switch on the front of the Remote UI.
The power source output remains OFF during Gas Purge.
FIGURE B.5
B-8