Sony DMW-S01NL Installation Manual page 93

AV I/O Block error messages
Following is a list of error messages displayed by the
Hardware Properties tool for the AV I/O Block, with
steps to take to deal with the error.
Item
Cognition
Hardware Status
AV Processing Board error messages
Following is a list of error messages displayed by the
Hardware Properties tool for the AV Processing
Board, with steps to take to deal with the error.
Error message/Symptom
ERTG1001:
Component Test Failed
ERTG1002:
Codec 1 Test Failed
ERTG1003:
Codec 2 Test Failed
ERTG1004:
Memory Tests Failed
During Output Test 1 or 2, no image is
shown on the monitor.
SDTI Interface Board error messages
Refer to the DMW-IF01 SDTI Interface Board Installation
Manual.
AV I/O Block Error Messages
Error Message
NG
NG
AV Processing Board Error Messages
Description
It will fail if a PCI device does not
respond as expected to the
configuration read.
It will fail if the compression/
decompression does not complete
successfully on the HUB port 5.
It will fail if the compression/
decompression does not complete
successfully on the HUB port 1.
It will fail if the data read from and
written to the memory do not match.
Monitor or AV Processing Board error
Description
Hardware was not found.
• USB driver broken
• Hardware fault
• Internal USB cable not
connected
• Hardware fault, especially in
the internal DC-DC converter
• Power not supplied because
of CPU block fault
Steps to take
Contact your Sony service representative.
Check that the monitor is connected and
working properly. If the problem persists,
contact your Sony service representative.
Steps to take
Contact your Sony service
representative.
4-29
Chapter 4 Maintenance