Complete The Ftd Initial Configuration - Cisco Firepower 2100 Getting Started Manual

Firepower Threat Defense Deployment with FMC
many processes running in the background all the time, and losing power does not allow the graceful shutdown
of your system.
Procedure
Step 1
Attach the power cord to the device and connect it to an electrical outlet.
Step 2 Press the power switch on the back of the device.
Step 3
Check the PWR LED on the front of the device; if it is solid green, the device is powered on.
Step 4 Check the SYS LED on the front of the device; after it is solid green, the system has passed power-on
diagnostics.
Note

Complete the FTD Initial Configuration

Connect to the FTD CLI to perform initial setup, including setting the Management IP address, gateway, and
other basic networking settings using the setup wizard. The dedicated Management interface is a special
interface with its own network settings. You will also configure FMC communication settings. You can only
configure the Management interface settings; you must configure data interface settings in FMC.
Note
You cannot repeat the CLI setup wizard unless you clear the configuration; for example, by reimaging.
However, all of these settings can be changed later at the CLI using configure network commands. See the
FTD command
Before you move the power switch to the OFF position, use the shutdown commands so that the
system can perform a graceful shutdown. This may take several minutes to complete. After the
graceful shutdown is complete, the console displays
panel blue locator beacon LED lights up indicating the system is ready to be powered off. You can
now move the switch to the OFF position. The front panel PWR LED flashes momentarily and turns
off. Do not remove the power until the PWR LED is completely off.
See the FXOS Configuration Guide
reference.
Complete the FTD Initial Configuration
It is safe to power off now
for more information on using the shutdown commands.
Cisco Firepower 2100 Getting Started Guide
. The front
71