(Optional) Change The Ip Address - Cisco Firepower 2100 Getting Started Manual

(Optional) Change the IP Address

Step 4 Check the SYS LED on the front of the device; after it is solid green, the system has passed power-on
diagnostics.
Note
(Optional) Change the IP Address
If you cannot use the default IP address for ASDM access, you can set the IP address at the ASA CLI.
Note
This procedure restores the default configuration and also sets your chosen IP address, so if you made any
changes to the ASA configuration that you want to preserve, do not use this procedure.
Procedure
Step 1 Connect to the ASA console port, and enter global configuration mode. See
on page 111
Step 2
Restore the default configuration with your chosen IP address.
configure factory-default [ip_address [mask]]
Note
Example:
ciscoasa(config)# configure factory-default 10.1.1.151 255.255.255.0
Based on the management IP address and mask, the DHCP address
pool size is reduced to 103 from the platform limit 256
WARNING: The boot system configuration will be cleared.
The first image found in disk0:/ will be used to boot the
Cisco Firepower 2100 Getting Started Guide
102
Before you move the power switch to the OFF position, use the shutdown commands so that the
system can perform a graceful shutdown. This may take several minutes to complete. After the
graceful shutdown is complete, the console displays
panel blue locator beacon LED lights up indicating the system is ready to be powered off. You can
now move the switch to the OFF position. The front panel PWR LED flashes momentarily and turns
off. Do not remove the power until the PWR LED is completely off.
See the FXOS Configuration Guide
for more information.
This command does not clear the currently-set mode, Appliance or Platform, for the Firepower
2100.
ASA Appliance Mode Deployment with ASDM
It is safe to power off now
for more information on using the shutdown commands.
. The front
Access the ASA and FXOS CLI,