Performing The Initial Configuration - Cisco VG202 Quick Start Manual

Enter no to proceed with manual configuration using the command-line interface (CLI):
Step 3
Would you like to enter the initial configuration dialog? [yes/no]: no
Would you like to terminate autoinstall? [yes]
Press Return to terminate autoinstall and continue with manual configuration.
Step 4
The system displays several messages, ending with lines similar to the following:
Copyright (c) 2013 by Cisco Systems, Inc.
Compiled <date> <time> by <person>
Press Return to bring up the
Step 5
flashfs[4]: Initialization complete.
VG>
Enter privileged EXEC mode:
Step 6
VG> enable
VG#
10

Performing the Initial Configuration

You initially configure your voice gateway by using the Cisco IOS CLI. Then you use the setup command which guides you
through the configuration process by prompting you for the specific information that is needed to configure your system. After
creating the initial configuration file, you can use the Cisco IOS CLI to perform further configuration.
Configuring the Voice Gateway by Using the Cisco IOS CLI
•
Configuring the Voice Gateway by Using the setup Command
•
• Verifying and Saving Your Configuration
Configuring the Voice Gateway by Using the Cisco IOS CLI
Procedure
Set up a console connection to your voice gateway.
Step 1
The system displays the following message:
...
voice gateway con0 is now available
Press Return or Enter.
Step 2
The system displays the following message:
Cisco Configuration Professional Express (Cisco CP Express) is installed on this device.
This feature requires the one-time use of the username "cisco"
with the password "cisco." The default username and password have a privilege level of 15.
Please change these publicly known initial credentials using Cisco CP Express or the Cisco IOS CLI.
Here are the Cisco IOS commands.
username <myuser>
no username cisco
Replace <myuser> and <mypassword> with the username and password you want to use.
For more information about Cisco CP Express, please follow the instructions in the QUICK START GUIDE for
your voice gateway...
...
User Access Verification
Username:
prompt:
VG>
privilege 15 secret 0 <mypassword>
15