Log Into Asdm - Cisco Firepower 2100 Getting Started Manual

ASA Appliance Mode Deployment with ASDM
system on the next reload.
Verify there is a valid image on disk0:/ or the system will
not boot.
Begin to apply factory-default configuration:
Clear all configuration
Executing command: interface management0/0
Executing command: nameif management
INFO: Security level for "management" set to 0 by default.
Executing command: ip address 10.1.1.151 255.255.255.0
Executing command: security-level 100
Executing command: no shutdown
Executing command: exit
Executing command: http server enable
Executing command: http 10.1.1.0 255.255.255.0 management
Executing command: dhcpd address 10.1.1.152-10.1.1.254 management
Executing command: dhcpd enable management
Executing command: logging asdm informational
Factory-default configuration is completed
ciscoasa(config)#
Step 3 Save the default configuration to flash memory.
write memory

Log Into ASDM

Launch ASDM so you can configure the ASA.
The ASA includes 3DES capability by default for management access only, so you can connect to the License
Authority and also use ASDM immediately. You can also use SSH and SCP if you later configure SSH access
on the ASA. Other features that require strong encryption (such as VPN) must have the Strong Encryption
license enabled, which requires you to first register to the License Authority.
Note
If you attempt to configure any features that can use strong encryption before you have the license—even if
you only configure weak encryption—then your HTTPS connection will be dropped on that interface, and
you cannot reconnect. The exception to this rule is if you are connected to a management-only interface, such
as Management 1/1. SSH is not affected. If you lose your HTTPS connection, you can connect to the console
port to reconfigure the ASA, connect to a management-only interface, or connect to an interface not configured
for a strong encryption feature.
Before you begin
• See the
Procedure
Step 1 Enter the following URL in your browser.
ASDM release notes on Cisco.com for the requirements to run ASDM.
Cisco Firepower 2100 Getting Started Guide
Log Into ASDM
103