Cisco Firepower 2100 Getting Started Manual page 83

Firepower Threat Defense Deployment with FMC
policies only support security zones; you can use zones or interface groups in NAT policies, prefilter
policies, and QoS policies.
e) Click the IPv4 and/or IPv6 tab.
f) Click OK.
Step 4 Click the Edit ( ) for the interface that you want to use for outside.
The General tab appears.
a) Enter a Name up to 48 characters in length.
For example, name the interface outside.
b) Check the Enabled check box.
c) Leave the Mode set to None.
• IPv4—Choose Use Static IP from the drop-down list, and enter an IP address and subnet mask in
slash notation.
For example, enter 192.168.1.1/24
• IPv6—Check the Autoconfiguration check box for stateless autoconfiguration.
Cisco Firepower 2100 Getting Started Guide
Configure Interfaces
81