Performing The Initial Configuration On The Voice Gateway; Using The Setup Command Facility - Cisco VG310 Hardware Installation Manual

Configuring the Cisco VG310 and Cisco VG320 Voice Gateways

Performing the Initial Configuration on the Voice Gateway

Use the following tools to perform the initial configuration on the voice gateway:
•
•
•

Using the setup Command Facility

Before You Begin
The setup command facility prompts you to enter the information that is needed to configure Cisco VG310
or Cisco VG320 quickly. The facility steps you through a initial configuration, including LAN and WAN
interfaces. For more general information about the 4719407618 command facility, see the chapter Configuration
Using Setup and Autoinstall in the Cisco IOS Configuration Fundamentals Configuration Guide, Release
12.4, at
This section explains how to configure a hostname for the voice gateway, set passwords, and configure an
interface for communication with the management network.
Note If you make a mistake while using the setup command facility, you can exit and run the setup command
facility again. Press Ctrl-C, and enter the setup command in privileged EXEC mode (
Procedure
Step 1
From the Cisco IOS CLI, enter the setup command in privileged EXEC mode:
Router> enable
Password: <password>
Router# setup
Continue with configuration dialog? [yes/no]:
You are now in the Setup Configuration Utility.
Step 2 To proceed using the setup command facility, enter yes.
The following message is displayed:
Continue with configuration dialog? [yes/no]:
At any point you may enter a question mark '?' for help.
OL-31292-01
If the prompt is displayed, your system has booted in ROMmon mode. For information on
rommon 1>
the ROMmon, see the section on using the ROMmon in the
Voice Gateway Software Administration and Configuration Guide
Using the setup Command Facility, on page 55
Using Cisco Configuration Professional Express, on page 58
Using Cisco IOS CLI—Manual Configuration, on page 58
Configuration Fundamentals Configuration Guide, Cisco IOS Release
--- System Configuration Dialog ---
Performing the Initial Configuration on the Voice Gateway
Cisco VG310 and Cisco VG320 Voice Gateways Hardware Installation Guide
Cisco VG350, Cisco VG310 and Cisco 320
at Cisco.com.
15.0S.
Router#
).
55