Cisco Firepower 2100 Getting Started Manual page 145

ASA Platform Mode Deployment with ASDM and Firepower Chassis Manager
• 1 stop bit
You connect to the FXOS CLI. Enter the user credentials; by default, you can log in with the admin user and
the default password, Admin123. You are prompted to change the admin password when you first log in.
Step 2
Connect to the ASA:
connect asa
Example:
firepower-2110# connect asa
Attaching to Diagnostic CLI ... Press 'Ctrl+a then d' to detach.
Type help or '?' for a list of available commands.
ciscoasa>
Step 3 To return to the FXOS console, enter Ctrl+a, d.
Connect to FXOS with SSH
You can connect to FXOS on Management 1/1 with the default IP address, 192.168.45.45. If you configure
remote management
you can also connect to the data interface IP address on the non-standard port, by default, 3022.
To connect using SSH to the ASA, you must first configure SSH access according to the
configuration
You can connect to the ASA CLI from FXOS, and vice versa.
FXOS allows up to 8 SSH connections.
Before you begin
To change the management IP address, see
or Gateway, on page
Procedure
Step 1
On the management computer connected to Management 1/1, SSH to the management IP address (by default
https://192.168.45.45, with the username: admin and password: Admin123).
You can log in with any username if you added users in FXOS. If you configure remote management, SSH
to the ASA data interface IP address on port 3022 (the default port).
Step 2
Connect to the ASA CLI.
connect asa
To return to the FXOS CLI, enter Ctrl+a, d.
Example:
firepower-2110# connect asa
Attaching to Diagnostic CLI ... Press 'Ctrl+a then d' to detach.
((Optional) Configure Management Access for FXOS on Data Interfaces, on page
guide.
125.
(Optional) Change the FXOS and ASA Management IP Addresses
Cisco Firepower 2100 Getting Started Guide
Connect to FXOS with SSH
141),
ASA general operations
143