Table of Contents
Advertisement
Chapter 2 RF Gateway 1 Configuration Quick Start
Configuring the IP Address Through the Front
Panel
The RF Gateway 1 management port IP address can be configured using the LCD
and keypad located on the chassis front panel.
To Configure the Management Port IP Address
1
After the system fully initializes, use the keypad to page down until you see the
mgmt port IP address.
Note: Use the up/down, left/right buttons for navigation and changes. Use the
center button for saving changes.
2
Page down to position the cursor in the IP address field. Use the left/right keys
to navigate the cursor below the numbers you want to change. Use the
up/down keys to make changes. Continue until all numbers are configured as
desired.
3
Use the center key to accept changes and exit the mgmt port IP address field.
4
Page right to find and configure the management port subnet mask and default
gateway. Configure each as desired.
5
Once finished, use the center key to enter and save information.
6
Reboot the RF Gateway 1. The management port IP address is not dynamically
configurable, thus reboot/power-cycle is required after changes.
7
The management port IP address can be validated by checking the configuration
settings on the LCD after reboot.
Note: Alternatively, the operator can attempt to connect to the web GUI at the
new IP address via HTTP after reboot.
4
78-4025112-01 Rev H0
Advertisement
Table of Contents
