Settings For Dynamic Route Planning - VDO MS 4150 RS MP3 Installation And Owner's Manual

I
Limit (xx/h)
This enables you to specify a value manually so that a speed warning will be given if
you exceed this speed (useful if using winter tyres, for example).
Select "
Select " ," if you wish to deactivate the speed warning.
I
Aud. Warning
Select "
the legal and manually set speed limit.
Guidance screen
Here you can select the information which should appear on the guidance screen.
I
Show event
Select whether traffic obstructions on your route should appear in the top line of
the guidance screen or not.
I
Remain. distance
Select whether the distance-to-go to the destination or via point should appear in
the status field of the guidance screen or not.
I
Times
Select which times should appear in the status field of the guidance screen. The
following options are available:
–
Current time
–
Time of arrival
–
Remaining time
–
No time display
Dyn. Route sett.

Settings for dynamic route planning

This setting is only possible when "
menu, a TMC station is received (on the radio or via an optional TMC receiver) and a
map CD is inserted.
I
Re-route lev.
Use this setting to specify whether the navigation system should plan a detour in the
event of traffic obstructions or not. Five levels are available. The lowest level (1) means
that the direct route should go through the stationary traffic depending on the
conditions and the anticipated delay. If the highest level is selected, an alternative
route should be planned in most cases.
✎
Level 3 is a standard setting for dynamic route planning. It is the factory setting
(default).
I
Horizon
This setting determines the radius in which the navigation system should take traffic
obstructions into account when planning your route. Select a value between 25 and
150 km.
" and set the desired limit for the fixed speed warning.
" to activate and deactivate the audible speed warning for
" is activated in the route selection
NAVIGATION
k
69