Connect To Network And Devices; Ethernet; Wi-Fi - NEC UNIVERGE GT890 User Manual

Connect to Network and Devices

The phone supports a variety of network connections (Ethernet, Wi-Fi) and device connections, including
EHS headset (Poly), USB, SD card and Bluetooth device. You can connect the phone and transfer files
from/to the GT890 using a USB connection, SD card or Bluetooth.

Ethernet

Ethernet connection is turned on as DHCP by default. If you would like to use Ethernet connection for
network access, please make sure the Ethernet cable is plugged in to the LAN port on the back of the
phone.
To configure Ethernet settings on the LCD:
1. Go to the application menuSettingsNetworkEthernet settings.
In Preferred Internet protocol, and select internet protocol you use. By default, it's "IPv4 only".
Note:
IPv6 is not supported. Please leave this setting as default.
2. Tap IPv4 settings.
3. Tap IPv4 address Type to select DHCP, Static IP or PPPoE as the address type.
 For DHCP, save the setting and the GT890 should be able to get IP address from the DHCP server
in the network.
 For static IP, enter IP Address, Subnet Mask, Default Gateway, DNS Server and Alternative DNS
server for the GT890 to correctly connect to the network.
 For PPPoE, enter PPPoE account ID and password so phone can get an IP address from the
PPPoE server.
Note:
Although IPv6 settings will be used to configure the IPv6 address type, IPv6 is not supported. Please
leave this setting as default.

Wi-Fi

WI-FI is supported and built-in on the phone. The phone can be connected to network if Wi-Fi is available
within the area.
216