Bluetooth Audio (Type D And E Audio); Media Format; Setting Bluetooth Audio - Subaru Forester 2012 Owner's Manual

®
Bluetooth audio (type D and
E audio)
This function enables you to play back
audio sources from Bluetooth
devices. You need to register the Blue-
®
tooth audio device in the system before
using it.
NOTE
The Bluetooth word mark and logo are
registered trademarks of Bluetooth
SIG, Inc.
& Media format
®
Bluetooth audio devices cannot be
connected if they are not compatible with
®
the following Bluetooth profiles.
. A2DP (Advanced Audio Distribution
Profile)
. AVRCP (Audio/Video Remote Control
Profile)
S05BH
& Setting Bluetooth
®
audio
1. Select "BT-A SETUP" by pressing the
"MENU" button (type D audio)/Select "BT
Audio Setup" by operating the "TUNE/
TRACK" dial (type E audio).
2. Perform the following procedure by
operating the "TUNE/TRACK" dial while
"BT-A" (type D audio)/"BT Audio" (type E
audio) is displayed.
NOTE
You cannot set a Bluetooth
while driving.
!
Registering (pairing) device
1. Select the "PAIR AUDIO" (type D
audio)/"Pair Audio Player" (type E audio)
menu. If a device is already registered,
"MEMORY FULL" is displayed and the
mode changes to the Bluetooth
setting mode.
2. After the passkey is shown on the
display, input the passkey into the device.
S05BH01
If you input the correct passkey, "PAIRED"
is displayed and the registering procedure
is finished. If you input an incorrect
passkey, "FAILED" is displayed, the re-
gistering procedure was not successful
and the mode changes to the Bluetooth
audio setting mode.
®
audio
NOTE
S05BH02
After the ignition switch is turned to the
"LOCK"/"OFF" position, the registered
device is not automatically connected
to the system even if the ignition switch
is turned to the "Acc" or "ON" position.
!
Selecting device
1. Select the "SELECT AUDIO" (type D
audio)/"Select Audio Player" (type E
audio) menu. If no devices are registered,
"EMPTY" is displayed and the mode
®
audio
changes to the Bluetooth
mode.
2. Select the "CONFIRM" menu. If the
device is connected, "SELECTED" is
S05BH0201
displayed and the selecting procedure is
finished. If the device cannot be con-
nected, "FAILED" is displayed and the
selecting procedure was not successful.
®
audio
!
Setting passkey
1. Select the "SET PASSKEY" menu.
After the currently set passkey is dis-
played, a new passkey can be entered.
2. Input the new passkey by operating
the "TUNE/TRACK" dial.
5-37
Audio
®
S05BH0202
®
audio setting
S05BH0203
– CONTINUED –