Record+Stream Button; Bitrate Button; Operation Mode - Datavideo HS-1600T Instruction Manual

4 channel hd/sd hdbaset portable video streaming studio
Hide thumbs Also See for HS-1600T:
Table of Contents

Advertisement

 When the STREAM button is solid white, this indicates that the stream function has been
successfully terminated.

Record+Stream Button

Start recording/streaming simultaneously
 When idle, the RECORD+STREAM button is solid white.
 Press and hold the RECORD+STREAM button for approximately 2 seconds.
 When the record and stream functions are activating simultaneously, the RECORD+STREAM
button turns from solid white, then blinking red and finally to solid red.
 When the RECORD+STREAM button is solid red, this indicates that the record and stream
functions have been successfully activated.
Stop recording/streaming simultaneously
 While recording and streaming simultaneously, the RECORD+STREAM button is solid red.
 Press and hold the RECORD+STREAM button for approximately 2 seconds.
 When the record and stream functions are terminating, the RECORD+STREAM button turns
from solid red, then blinking red and finally to solid white.
 When the RECORD+STREAM button is solid white, this indicates that the record and stream
functions have been successfully terminated.

Bitrate Button

Follow the steps below to switch the stream bitrate mode using the BITRATE button:
 Press and hold one of the RECORD+STREAM, RECORD and STREAM buttons until the pressed
button starts blinking red.
 Continue holding down one of the RECORD+STREAM, RECORD and STREAM buttons while
pressing the BITRATE button to switch stream bitrate mode (H, M or L).
Note: The system will return to original settings if the BITRATE button push is not sensed. The
default bitrate is M.

Operation Mode

Checking the NVS-31's operation mode
Follow the steps below to check the NVS-31's current operation mode:
 First make sure the stream and record functions are in idle state, i.e. STREAM and RECORD
buttons are solid white.
 Press RECORD or STREAM button.
 The button LED should behave according to the device's operation mode. The LED behaviors
are summarized in the table below:
Solid red STREAM button
Solid white STREAM button Record Only Mode
Solid red RECORD button
Stream & Record
77
Solid white RECORD button
Stream Only Mode
None

Advertisement

Table of Contents
loading

Table of Contents