Stream Button; Operation Mode - Datavideo HS-1600T Instruction Manual

Stop recording
 While recording, the RECORD button is solid red.
 Press and hold the RECORD button for approximately 2 seconds.
 When the record function is terminating, the RECORD button turns from solid red, then
blinking red and finally to solid white.

When the RECORD button is solid white, this indicates that the record function has been
successfully terminated.

Stream Button

Press the STREAM button to start/stop streaming.
Start streaming
 When idle, the STREAM button is solid white.
 Press and hold the STREAM button for approximately 2 seconds.
 When the stream function is activating, the STREAM button turns from solid white, then
blinking red and finally to solid red.
 When the STREAM button is solid red, this indicates that the record function has been
successfully activated.
Note: The STREAM button is disabled in the Record Only mode.
Stop streaming
 While streaming, the STREAM button is solid red.
 Press and hold the STREAM button for approximately 2 seconds.
 When the stream function is terminating, the STREAM button turns from solid red, then
blinking red and finally to solid white.

When the STREAM button is solid white, this indicates that the stream function has been
successfully terminated.

Operation Mode

Checking the NVS-31's operation mode
 First make sure the stream and record functions are in idle state, i.e. STREAM and RECORD
buttons are solid white.
 Press RECORD or STREAM button.
 The button LED should behave according to the device's operation mode. The LED behaviors
are summarized in the table below:
Solid red
STREAM button
Solid white
STREAM button
 The two buttons turn solid white a few seconds after displaying the operation mode.
Solid red RECORD button
Stream & Record
Record Only Mode
Solid white RECORD button
Stream Only Mode
None
74