Assembling The Light Kit - Hunter Gilmour Installation Manual

1886
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Partially install two of the light kit screws found
in the bag. It does not matter which two
screw holes you choose. Connect the plugs
from the upper and lower switch housings.
Make sure to line up the colored markings on
the connectors.
Note:
Fan style may vary.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
7
Ceiling Bracket

Assembling the Light Kit

2 of 6
Light Kit Screw
bag
Feed the wire plug through the center hole
of the upper switch housing, then wrap
keyhole slots around the screws and twist
counterclockwise.
2 of 6
Light Kit Screw
bag
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
Installing the Globe
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan Wiring
Tab
Attach the globe by lifting and
Notch
turning clockwise one third of a
full turn of the globe until it stops.
NOTE: Check to ensure
proper engagement.
Canopy Blades
bag
Insert the third screw, found in the
bag, into place and then tighten all three screws.
Turn the light kit counterclockwise until the light
kit screws are firmly situated in the narrow end
of the keyhole slots. Install the third screw and
tighten all three screws securely.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
WARNING
GLOBE FALL HAZARD
To prevent SERIOUS INJURY, make sure that
globe is properly secured.
Light Bulbs
1 of 6
Light Kit Screw
hardware
1 of 6
Light Kit Screw
bag
Remote