Table of Contents
Advertisement
1886
IMPORTANT
NOTE: The blade arms should be mounted with
the ridge facing downward. Installing it incorrectly
could result in your fan not functioning.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Insert the third screw, found in the
bag, in place and firmly tighten all the three screws.
Note:
Fan style may vary.
7
Ceiling Bracket
Top housing
Installing the Blades
Assembling the LIght Kit
2 of 3
Light Kit Screw
bag
Feed the 9-pin plug connector coming
from the bottom of the motor housing
through the center hole in the light kit
assembly. Connect it to the plug connector
found in the switch housing area of the
light kit assembly. Make sure to line up
the colored markings on the connectors.
1 of 3
Light Kit Screw
bag
hardware
Carefully push all switch housing components
into the switch housing, then install the switch
housing plate using two short light kit assembly
screws, found in the
Hanging Fan
Ridge
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Wrap the keyhole slots around the
screws and twist counterclockwise.
hardware bag.
Wiring
Canopy
Blade Arm Screw
bag
Lightly attach the blade arms to the motor with
screws found in the
hardware bag, then
securely tighten after both screws are attached.
Repeat x4
Note:
Fan style may vary.
2 of 2
Short Light Kit
Screw
bag
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Blades
Light
x8
Glass/Bulbs
Advertisement
Table of Contents
