Assembling The Light Kit - Hunter Anisten 52774 Installation Manual

Table of Contents

Advertisement

Partially install two light kit assembly screws,
found in the
hardware bag, halfway into
the motor housing as shown. It does not
matter which two screw holes you choose.
Partially install two of the light kit screws found
in the
bag.
Note:
Fan style may vary.
Install the included bulbs into
the sockets. When necessary,
replace with bulbs of same
wattage.
Note:
Fan style may vary.
Ceiling Bracket
Downrod

Assembling the Light Kit

2 of 6
Light Kit Screw
bag
Feed the wire plug through the center hole
of the upper switch housing, then wrap
keyhole slots around the screws and twist
counterclockwise.
2 of 6
Light Kit Screw
bag
Lift the light kit and connect the single-pin connectors to the
connectors from the fan. Connect the white wires together.
Connect the blue and black wires together. Align the keyhole
slots in the light kit housing with the two screws. Make sure
all the wires from the fan and the light kit are snug inside
the center of the light kit, not pinched in between the upper
switch housing and the light kit or hanging out of the sides.
Installing the Globe
Tab
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan
Wiring
Insert the third screw, found in the
bag, into place and then tighten all three screws.
Connect 3-pin to the plug connector found in the
switch housing area of the light kit assembly.
Make sure to line up the colored markings on the
connectors.
Turn the light kit counterclockwise until the light
kit screws are firmly situated in the narrow end
of the keyhole slots. Install the third screw and
tighten all three screws securely.
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the globe until it stops.
NOTE: Check to ensure
proper engagement.
GLOBE FALL HAZARD
To prevent SERIOUS INJURY, make sure that
globe is properly secured.
Canopy
Blades
1 of 6
Light Kit Screw
bag
hardware
1 of 6
Light Kit Screw
bag
WARNING
ON
WARNING
Light
Bulbs/Glass
1886
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Anisten 52775

Table of Contents