Related Manuals for Hunter 51330
Summary of Contents for Hunter 51330
- Page 1 Gilmour Installation Manual Model: 51330 Flat Matte Black 51840 Matte Fresh White Fan weight ±2 lbs: 19.4 lbs (8.8 kg) ©2020 Hunter Fan Co. PG3840 r022020...
- Page 2 - All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 3 We recommend that you pull everything out of the box and lay it out. We have grouped the drawn components below with the hardware you’ll need for those Hunter Pro Tip: parts. The screws below are drawn to scale to make it easier to identify what piece of hardware is needed to install each component.
-
Page 4: Choosing The Right Installation Location
Installing the Ceiling Bracket You have two options for installation. Pick which one works best for your location. Remove any existing bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box. Do this first! -
Page 5: Hanging The Fan
1886 Installing the Top Housing Top Housing Top Housing Screw Adapter Install the top housing screws. These Thread the wires through the top housing. Place the top screws can be found in the housing onto the motor housing so that the holes in the hardware bag. -
Page 6: Wiring The Fan
If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualified electrician. You are going to need these: Hunter Pro Tip: Here is how to connect the wires: 4 Wire Nuts (these are in the... -
Page 7: Installing The Canopy
1886 Installing the Canopy 2 of 3 Canopy Screws Swing the fan up to align the Hold the canopy up with the screw holes Place the receiver inside the canopy screw holes with the aligned. Partially install two canopy screws, canopy. -
Page 8: Assembling The Light Kit
1886 Assembling the Light Kit 2 of 6 1 of 6 Light Kit Screw Light Kit Screw Partially install two light kit assembly screws, found in the hardware bag, halfway into Feed the wire plug through the center hole the motor housing as shown. of the upper switch housing, then wrap It does not matter which two Insert the third screw, found in the... -
Page 9: Preparing The Remote
1886 Preparing the Remote For your convenience, a remote function card The remote transmitter is already is packed in with your remote. paired to the receiver and ready to use. Dimming mode is off by default. Note: If you need to pair your remote, To access the battery compartment, turn fan power off and back on at the remove the the battery door to the... -
Page 10: Limited Lifetime Warranty
Hunter instructions, accidental damage caused by the fan owner or related parties, Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. modifications to the fan, improper or incorrectly performed maintenance or repair,... -
Page 11: Troubleshooting
“How do I properly install multiple remote-controlled fans?” for information on how to correct this issue. Hunter Pro Tip: Cleaning the Fan Use soft brushes or cloths to prevent scratching. Cleaning products may damage the finishes.