Table of Contents
Advertisement
Partially install two light kit
screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Insert the third screw, found in the
bag, in place and firmly tighten all the three screws.
Note:
Fan style may vary.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Ceiling Bracket
Downrod
Assembling the LIght Kit
2 of 5
Light Kit Screw
bag
Feed the 9-pin plug connector coming
from the bottom of the motor housing
through the center hole in the light kit
assembly. Connect it to the plug connector
found in the switch housing area of the
light kit assembly. Make sure to line up
the colored markings on the connectors.
1 of 5
Light Kit Screw
bag
hardware
Installing the Bulbs and Cage
3 of 4
Cage Assembly
Screw
bag
Partially install three cage assembly
screws, found in the
hardware bag,
halfway into the light kit as shown. It does
not matter which screw holes you choose.
Hanging Fan
Carefully push all switch housing components
into the switch housing, then install the switch
housing plate using two light kit screws, found
in the
hardware bag.
Lift cage and align the keyhole slots
in the top of the cage assembly with
the partially installed cage assembly
screws. Wrap the keyhole slots around
the screws and twist counterclockwise.
Wiring
Canopy
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Wrap the keyhole slots around the
screws and twist counterclockwise.
2 of 5
Light Kit Screw
bag
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
bag
Insert the fourth screw, found in
the
hardware bag, in place and
firmly tighten all the four screws.
NOTE: Check to ensure
proper engagement.
Blades
Bulbs
1886
1 of 4
Cage Assembly
Screw
8
Remote
Advertisement
Table of Contents
