Installing The Canopy; Installing The Blades - Hunter Gilmour Installation Manual

Place the receiver inside the
canopy. Ensure the wires
remain connected.
Partially install a canopy screw, found
in the hardware bag, between
the ceiling plate hooks. When all the
holes are properly aligned, securely
tighten all three canopy screws.
Note:
Fan style may vary.
Ceiling Bracket Hanging Fan

Installing the Canopy

Swing the fan up to align the
canopy screw holes with the
mounting holes on the ceiling plate.
Note: The slots in
the canopy must
remain engaged while
swinging the canopy
for alignment.
Ceiling Plate Hooks
Canopy
bag Screws

Installing the Blades

NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
Wiring
Hold the canopy up with the screw holes
aligned. Partially install two canopy screws,
found in the
holes opposite the ceiling plate hooks.
1 of 3
Put the blade washers found in the
bag onto the blade screws found in the
hardware bag. Then install the blade screws to
secure each blade to the fan.
Repeat x3
IMPORTANT
Canopy Blades
bag
hardware bag, into the
WARNING
FAN FALL HAZARD
Make sure screws are tight.
Blade Screw
bag
hardware
Blade Washer
bag
Light Bulbs
1886
2 of 3
Canopy
Screws
x9
x9
6
Remote