Adjusting The Height Of The Push Bar; Adjusting The Angle Of The Push Bar; Seat; Width Adjustment Seat - Invacare Rea Dahlia 30 User Manual

3.6.2 Adjusting the height of the push bar

A
1. Loosen the hand wheels A.
2. Adjust the handles to the required height position.
There are two fixed positions available.
3. Re-tighten the hand wheels.
WARNING!
Risk of injury
The push bar can loosen from the attachments
– Make sure that the marking B on the tubes are
fitted against the backrest tube.
– Check that the handwheels can be tightened
properly, the screw of the handwheel should
barely be visible. If the push bar is in the wrong
position, the handwheel will not be possible to
tighten properly.

3.6.3 Adjusting the angle of the push bar

B
1. Press the buttons A.
2. Adjust the push bar B to the preferred angle.
3. Release the buttons A.
Move the push bar slightly in order for the buttons
to lock into position.
1572307-J
B
A
WARNING!
Risk of imbalance
– Do not hang anything on the push bar, this
could cause imbalance.

3.7 Seat

3.7.1 Width adjustment seat

A
1. Loosen the screw A with an Allen key.
Tools: 5 mm Allen Key
2. Adjust the armrests to the desired width.
3. Re-tighten the screw A.
Risk of poor adjustment
– There must not be any pressure on the armrest
/ legrest while adjusting the screw.

3.7.2 Adjusting the seat depth

1. Remove the seat cushion.
2. Loosen the screws A with an 5 mm Allen key.
3. Move the front edge of the seat forwards or backwards.
4. Re-tighten the screws A (5–6 Nm).
5. Put the seat cushion back.
The distance between the back of the knee/calf
and the cushion should be as small as possible, but
without contact.
Product Overview
15