Placing The Wires; Wires With Backrest Plate; Wires With Tension Adjustable Backrest; Inserting The Armrests - Invacare Rea Dahlia 30 User Manual

Rea® Dahlia® 30 / 45

5.5 Placing the wires

5.5.1 Wires with backrest plate

B
A
1. Thread the wires on the outside of the backrest tubes B.
2. Place the wires in the holders/clips A in order to hold
them in place.
Fold the slack of the wires under the seat to get
them out of the way.

5.5.2 Wires with tension adjustable backrest

B
1. Place the wires A and B as shown on the picture above.
Risk of damage to the wires
– It is important that the cable for the
assistant brake A is placed on the inside of
the backrest tubes.
2. Place the wire for the backrest/seat recline B outside of
the backrest tubes.
3. Place both of the wires on the inside of the backrest
attachment C.
4. Attach the wires to the backrest tubes E with the straps
D.
Fold the slack of the wires under the seat to get
them out of the way.
32
A
C
E
C
D
CAUTION!
Risk of reduced brake effect
– The wires must not be crossed on the backrest!

5.6 Inserting the armrests

WARNING!
Risk of pinching
– Be aware of the pinching risk due to the small
distance between the armrest attachment and
the rear wheel when tilting or propelling the
wheelchair.
A
1. Place the armrest in the armrest attachment A.
2. Press the armrests downwards until you can feel/hear
that the armrests are securely in place.
The armrests have an auto-lock to prevent
involuntary movement or detachment.
3. Press the auto-lock button B to release before removing
or adjusting the armrest.
Risk of damage to the product
– Make sure not to pinch or stretch the wire
to the tilt function when removing the
armrest if the wheelchair is equipped with
user maneuvered tilt.

5.7 Adjusting the armrest height

A
B
1572307-J