Fitting the foot plate extension
A
B
Tools: 3 mm fixed spanner
screwdriver
ON THE REAR AND SIDES OF CHAIRS WITH 20"–24" WHEELS
A
Tools: 4 mm Allen Key
10 mm fixed spanner
ON THE REAR AND SIDES OF CHAIRS WITH 20"–24" WHEELS
B
A
Tools: 4 mm Allen Key
REA BELLIS
Reflectors
B
C
C
10 mm fixed spanner
Fit the extension to the foot plate using the screws
(A) and nuts (B).
A
B
Fit the red refl ector on the back of the backrest tube
using the screw (A), washer (B) and nut (C).
Attach the orange refl ector to the spokes of the rear
wheels, by placing both clips (D) at a suitable distance
from each other, each of them around a spoke, and
then pushing the refl ector onto it.
NB! Ensure that the circlips are pressed through
the holes on the reflector sufficiently. If not, the
refl ector can fall off.
Attach the red reflector to the back of the backrest
tube using the screw (A), washer (B) and nut (C).
If the wheelchair is equipped with 16" wheels the
orange reflector must be attached to the side of
D
the wheelchair using the screw (D) and the square
nut (E).
E
19