You can also edit the access code of the
1 Press and hold
call return
2 Enter the access code using the number keypad (0-9),
.
redial/p
3 Press
again. You will hear a confirmation tone.
call return
Changing the Digital Security Code
The digital security code is an identification code used to connect the
handset and the base unit. Normally, setting the code is not necessary.
The first time you charge your handset, the security code is automatically
set. In the rare situation that you suspect another cordless telephone is
using the same security code, you can change the code.
4
5
6
ghi
jkl
mno
7
pqrs
8
tuv
9
wxyz
tone
0
#
oper
int'cm/page
volume
mic
call return
in standby mode until a tone sounds.
1 Remove the handset from the base unit.
Press and hold
int'cm/page
2 While the handset is emitting the paging
sound, replace the handset to the base unit and
continue to hold the
The paging tone stops. Release the
A random, new security code is set.
key on the base.
and
/tone
on the base.
for 3 seconds.
int'cm/page
int'cm/page
A D D I T I O N A L I N F O R M A T I O N [ 45 ]
note
If the handset battery
pack is completely
discharged or the battery
pack is removed, the
digital security code will
be lost. If this happens,
a new security code is set
automatically next time
the battery pack
is charged.
.