Uniden EXT1265 Owner's Manual page 11

D. Choose the dialing mode
Most phone systems use tone dialing, which sends DTMF tones through the
phone lines. However, some phone systems still use pulse dialing such as in
rural areas. The default setting is tone dialing. Depending on your dialing
system, set the mode as follows:
Base setting only
1 Press and hold call waiting
2 To set the dial mode for pulse dialing, press
mode for tone dialing, press
indicate the setting is complete.
• If you are not sure of your dialing system, set for tone dialing. Make a
trial call. If the call connects, leave the setting as is, otherwise set for
pulse dialing.
• If your phone system requires pulse dialing and you need to send the DTMF
tones for certain situations during a call, you may "switch-over" to tone
dialing (refer to "Tone Dialing Switch-over" on page 32).
until you hear a confirmation tone.
#
. A confirmation tone sounds to
. Or to set the dial
G E T T I N G S T A R T E D
note
Make sure your battery
pack is fully charged
before choosing the
dial mode.
[ 9 ]