Mounting The Base Unit On A Wall; Standard Wall Plate Mounting - Uniden EXT1265 Owner's Manual

!
DO NOT use an outlet
controlled by a
wall switch.
[ 10 ] G E T T I N G S T A R T E D

Mounting the Base Unit on a Wall

Setting the handset retainer clip for wall mounting
1 On the base unit, pull the handset retainer clip out of
the slot and rotate it clockwise 180 degrees.
2 Flip the retainer clip from front to back. Slide it back
into the slot so that the lip of the retainer is up and
the is down. The retainer holds the handset
ª
in place.

Standard wall plate mounting

This phone can be mounted on any standard
wall plate.
1 Route the AC adapter cord inside the molded
wiring channel as shown.
2 Plug the telephone line cord into the TEL
LINE jack. Route the cord inside the molded
wiring channel as shown.
3 Raise the antenna to a vertical position.
4 Align the mounting slots on the base with the mounting posts on the
wall. Then push in and down until the phone is firmly seated.
Flip the hook tab over
so the tab holds the
handset.
Raise the
antenna.
Telephone
Line Cord
Single-Line
Telephone Jack
(RJ11C)
Power Outlet
(AC 120V, 60Hz)
AC Adapter