DOK-CONTRL-S67DO8M122A-AP03-EN-P
Rexroth IndraControl S67 Digital Module 8 Outputs – 2.0 A (4×M12)
11
Maintenance and Service
11.1
General Information
11.2
Replacing Module
11.2.1
General Information
11.2.2
Disconnecting Wiring
11.2.3
Removing Module from System
11.2.4
Removing Module from Mounting Rail
This chapter provides information on maintenance and service.
To replace a S67-DO8-M12-2A module if a version changes for example,
proceed as described in the following chapters.
Before removing the male connectors, clean the S67-DO8-M12-2A module to
ensure that no dirt comes in contact with the connections. Otherwise, the
contacts can be damaged.
To unplug the cables, proceed as follows:
1. Disconnect the power supply from those devices the S67-DO8-M12-2A
module is mounted to.
CAUTION
Even when taking derating into account, high surface temperatures on
the metallic connector sockets and at the housing can arise during oper‐
ation. If the IndraControl S67 component was in operation, allow it to
cool off before touching it.
2. Unscrew all connections and remove the cables.
To remove the S67-DO8-M12-2A module from the system, proceed as fol‐
lows:
1. Disconnect the power supply from those devices the S67-DO8-M12-2A
module is mounted to.
2. Release the S67-DO8-M12-2A module from the system by unscrewing
the M4 screws.
For a clear figure, the mounting rail adapter in the figure below (B, C) is
shown without the S67-DO8-M12-2A module.
If the S67-DO8-M12-2A module is mounted on a mounting rail, proceed with
the removal as follows:
1. Disconnect the power supply from those devices the S67-DO8-M12-2A
module is mounted to.
2. To remove the S67-DO8-M12-2A module, press down the release lug of
the mounting rail adapter using a slotted screwdriver (B) and remove the
mounting rail adapter from the rail (C).
Bosch Rexroth AG
Maintenance and Service
Hot connector sockets!
51/69