Global Settings For Field Supply; Automatic Storage Of System Parameters; Firmware Update - Bosch Rexroth IndraControl S67 Series Application Description

DOK-CONTRL-S67DO8M122A-AP03-EN-P
Rexroth IndraControl S67 Digital Module 8 Outputs – 2.0 A (4×M12)
9.4

Global Settings for Field Supply

9.5

Automatic Storage of System Parameters

9.6

Firmware Update

Parameter Description
Diagnostics The channel-related diagnostics can be enabled/disabled (for
more information, refer to
module" on page
- Lock
- Unlock
Substitute value The substitute value strategy outputs the substitute value or
strategy the last output value (e.g a field bus is interrupted).
The following options are available:
- Add substitute value
- Retain last value
Substitute value Enter the substitute value used in case of error. In case of
error (e.g. field bus interruption), this value is used for the sub‐
stitute value strategy "Add substitute value".
- 0
①
- 1
Delivery state
①
The last value is a value reported at the contact before the in‐
②
terference. This can be a process value for example
Tab. 9-3: Overview on adjustable parameters for the digital outputs
In case of a short circuit, the field supply is switched off for 1,000 ms. The
field supply is subsequently switched on again. If the short circuit remains,
the procedure is repeated.
Some field bus couplers provide the "System Parameter Handling" function.
This function detects configuration changed at the IndraControl S67 node
and is used for the automatic module parameterization. If a module is to be
replaced due to a defect, the new module does not have to be parameter‐
ized. The stored parameters are automatically applied to the replaced mod‐
ule.
During a firmware update of the S67-DO8-M12-2A module, the stored mod‐
ule parameters can be overwritten. Thus, check the parameterization after a
firmware update.
The firmware can only be updated by the Bosch Rexroth Service.
Bosch Rexroth AG
tab. 9-2 "Channel diagnostics of the
44):
①
①
②
45/69
Parameterization