Direct Mounting To System; Mounting On Mounting Rail (Only With Bosch Rexroth Accessories); Fastening Mounting Rail Adapter At Module - Bosch Rexroth IndraControl S67 Series Application Description

24/69 Bosch Rexroth AG
Mounting Module
5.4

Direct Mounting to System

5.5 Mounting on Mounting Rail (only with Bosch Rexroth Acces‐
sories)
5.5.1

Fastening Mounting Rail Adapter at Module

Rexroth IndraControl S67 Digital Module 8 Outputs – 2.0 A (4×M12)
Two M4x12 screws are required to directly mount the S67-DO8-M12-2A
module. Select the length of the screw shaft with regard to the fastening type.
Drilling dimensions
When fastening the IndraControl S67 component without a threaded hole,
the clearance hole must not be wider than 4 mm to ensure a safe contact of
the FE connections.
Mount the S67-DO8-M12-2A module directly on a flat system surface without
using Bosch Rexroth accessories. To directly mount the module, proceed as
follows:
1. Disconnect the power supply from those devices on which the S67-
DO8-M12-2A module is to be mounted.
2. Mark the drilling holes. Use the drilling template printed on the packag‐
ing. Alternatively, position the S67-DO8-M12-2A module as desired and
mark the drill holes. Ensure that there is sufficient space around the
IndraControl S67 series component to connect all cables without prob‐
lems.
We recommend the use of Bosch Rexroth spacers for compact
direct mounting. If these spacers are used, the additional distance
from the second IndraControl S67 component onwards is to be
observed (see
Arrangement" on page
3. Fasten the S67-DO8-M12-2A module with the M4x12 screws via the two
fastening holes.
Fig. 5-1: Mount the module at a grounded frame of the system or another earth
connection point
A mounting rail adapter is required to mount the S67-DO8-M12-2A module
on mounting rails.
Screw the S67-DO8-M12-2A module with the mounting rail adapter using the
M4 threaded screws provided as shown in the figure below.
DOK-CONTRL-S67DO8M122A-AP03-EN-P
chapter 5.8 "Mounting Spacer in Case of Compact
28).
System