Uniden EXI2926 Owner's Manual page 9

900 mhz cordless telephone
Hide thumbs Also See for EXI2926:
Table of Contents

Advertisement

B B . . I I n n s s t t a a l l l l t t h h e e b b a a t t t t e e r r y y p p a a c c k k
C C h h a a r r g g e e t t h h e e b b a a t t t t e e r r y y p p a a c c k k f f o o r r a a t t l l e e a a s s t t 1 1 5 5 - - 2 2 0 0 h h o o u u r r s s b b e e f f o o r r e e p p l l u u g g g g i i n n g g t t h h e e p p h h o o n n e e l l i i n n e e i i n n t t o o y y o o u u r r p p h h o o n n e e . .
1) Press in on the batter y cover release and slide the cover down until it comes of f.
2) Connect the batter y pack connector observing correct polarity (black and red wires)
to the jack inside the batter y compar tment.
Do not exer t any force on this connection. It could cause damage to the batter y or
handset. The plastic connector will f it together only one way. Once you are cer tain
that you have made a good connection, then inser t the batter y pack into the batter y
compar tment. Do not pinch the wires.
3) Securely close the batter y compar tment cover by sliding it up until it snaps into place.
4) Place the handset on the base unit. Remove the beltclip, if attached, for face up charging.
B B a a t t t t e e r r y y u u s s e e t t i i m m e e ( ( p p e e r r c c h h a a r r g g e e ) )
From fully charged
• Seven hours continuous use.
• Four teen days when the handset is in the standby mode.
L L o o w w b b a a t t t t e e r r y y a a l l e e r r t t
When the batter y pack is ver y low and needs to be charged, the phone is programmed to
eliminate functions in order to save power. If the phone is not in use, "
appears on the LCD and none of the keys will operate.
If the phone is in use, "
conversation as quickly as possible and return the handset to the base unit for charging.
The last number dialed in the redial memor y is retained for up to 30 seconds. The handset
note
memor y backup can hold names and numbers stored in the memor y locations even if the batter y
pack is completely discharged.
" flashes and the handset beeps. Complete your
"
G E T T I N G S T A R T E D
note
• Use only the
Uniden Battery
(BT-905) supplied
with your phone.
Replacement
batteries are also
available through
the Uniden Parts
Department (See
page 5).
• Even when the
battery pack is
not being used,
it will gradually
discharge over a
long period of
time. For optimum
performance, be
sure to return the
handset to the
base unit
after each
telephone call.
• If you must replace
the battery pack
during a telephone
call, complete the
replacement of the
battery pack
within 30 seconds,
and you can
return to the
original call.
[ 7 ]

Advertisement

Table of Contents
loading

Table of Contents