Editing A Stored Name And/Or Phone Number - Uniden EXI2926 Owner's Manual

Editing a Stored Name and/or Phone Number

To edit a number you have stored in the handset.
1) Pick up the handset from the base.
2) Press and hold m for two seconds.
The display shows the "
name/numbers.
3) Use the Lup/int'com and dnM/conf, or number keypad, to select
the memor y location you would like to edit.
4) Press sel/vol. The display shows the memor y location you have
selected.
5) Press sel/vol again to enter the "
6) Press sel/vol. The following screen appears, and a cursor flashes
indicating that the display is ready to edit the name.
7) Enter the name with the Lup/int'com and dnM/conf.
Use the Lup/int'com and dnM/conf keys to enter symbols.
Use the / /tone and #/
* t
Press delete/flash to remove any unwanted character.
8) Press sel/vol. The following screen appears. A cursor flashes
indicating that the display is ready for the number to be edited.
9) Enter the phone number with the number keypad (direct entr y).
Press delete/flash to remove any unwanted character.
Press and hold delete/flash to clear the entire number.
10)Press sel/vol. The handset beeps and displays the conf irmation screen.
11)The display then returns to the "
number to edit (return to step 3) or press m to return to standby. To edit a number
stored in the base, repeat the steps for storing numbers in the base. (See page 21.)
This will simply overwrite the number that was previously stored in the location.
" screen and any saved
" mode.
keys to move the cursor left and right.
s
" screen. You may select another
note
• Whenever you are
using a menu
screen, you must
press a key within
20 seconds or the
phone will return
to standby. You
may also press m
to exit a memory
menu at any time.
• If you select "
" at any
time, no changes
are made and the
handset shows
the "
" screen.
M E M O R Y F E A T U R E S [ 23 ]