Table of Contents
Advertisement
D D . . C C h h o o o o s s e e t t h h e e d d i i a a l l i i n n g g m m o o d d e e
Most phone systems use tone dialing which sends DTMF tones through the phone lines.
However some phone systems still use pulse dialing such as in rural areas. The default setting is tone dialing.
Depending on your dialing system, set the P P U U L L S S E E - - T T O O N N E E switch as follows:
I I f f y y o o u u r r d d i i a a l l i i n n g g s s y y s s t t e e m m i i s s
Tone
Pulse
• If you aren´t sure of your dialing system,
make a trial call with the PULSE-TONE switch set to T T O O N N E E .
If the call connects, leave the switch as is; otherwise, set to P P U U L L S S E E .
• If your phone system requires pulse dialing and you need to send DTMF tones for cer tain situations during a
call, you may "switch-over" to tone dialing. (Refer to "Tone Dialing Switch-over" on page 15.)
Mounting the Base Unit on a Wall
S S e e t t t t i i n n g g t t h h e e h h a a n n d d s s e e t t r r e e t t a a i i n n e e r r c c l l i i p p f f o o r r w w a a l l l l m m o o u u n n t t i i n n g g
1) On the base unit, pull the handset retainer out of the slot. Rotate it clockwise
180 degrees.
2) Flip the retainer from front to back.
Slide it back into the slot so that the lip of the retainer is up and the
The retainer holds the handset in place.
S S e e t t t t h h e e s s w w i i t t c c h h t t o o
T T O O N N E E
P P U U L L S S E E
M
is down.
note
For 2 line
subscriptions,
• If the two phone
lines are in one
modular jack,
connect using TEL
LINE 1-2 jack.
• If the two phone
lines are on two
separate modular
jacks, connect
using both TEL
LINE 1-2 and TEL
LINE 2 jacks.
G E T T I N G S T A R T E D
[ 9 ]
Advertisement
Table of Contents
