Table of Contents
Advertisement
S S t t a a n n d d a a r r d d w w a a l l l l p p l l a a t t e e m m o o u u n n t t i i n n g g
This phone can be mounted on any standard telephone wall plate.
1) Snap the wall mount adapter into the notches on the base.
2) Plug the AC adapter to the DC IN 9V jack.
3) Wrap the AC adapter cord inside the molded wiring channel as shown.
4) Plug the AC adapter into a standard 120V AC wall outlet.
5) Place the handset on the base unit and charge for 15-20 hours.
6) Plug the telephone line cord into the TEL LINE jack.
!
Wrap the cord inside the molded wiring channel as shown.
7) Plug the telephone line cord into the telephone outlet.
8) Raise the antenna to a ver tical position.
DO NOT use an
9) Align the mounting slots on the base with the mounting posts on the wall
outlet controlled by
then push in and down until the phone is f irmly seated.
a wall switch.
D D i i r r e e c c t t w w a a l l l l m m o o u u n n t t i i n n g g
If you don´t have a standard wall plate, you can mount your phone directly to the wall. Before doing this,
note
consider the following:
• Avoid electrical cables, pipes, or other items behind the mounting location, that could cause a hazard
when inser ting screws into the wall.
If you have wall
mounted the base,
• Tr y to mount your phone within 6-10 feet of a working phone jack to avoid excessive cord lengths.
you must remove
the beltclip to hang
• Make sure the wall material is capable of suppor ting the weight of the base and handset.
the handset with
• Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable for the wall material
the display facing
forward.
where the base unit will be placed.
[ 10 ]
G E T T I N G S T A R T E D
1
2
Advertisement
Table of Contents
