Table of Contents
Advertisement
C C l l e e a a n n i i n n g g t t h h e e c c h h a a r r g g i i n n g g c c o o n n t t a a c c t t s s
T T o o m m a a i i n n t t a a i i n n a a g g o o o o d d c c h h a a r r g g e e , , i i t t i i s s i i m m p p o o r r t t a a n n t t t t o o c c l l e e a a n n t t h h e e b b a a t t t t e e r r y y c c o o n n t t a a c c t t s s o o n n t t h h e e
h h a a n n d d s s e e t t a a n n d d b b a a s s e e u u n n i i t t w w i i t t h h a a d d r r y y c c l l o o t t h h o o r r a a p p e e n n c c i i l l e e r r a a s s e e r r a a b b o o u u t t o o n n c c e e a a m m o o n n t t h h . .
D D o o n n o o t t u u s s e e a a n n y y l l i i q q u u i i d d s s o o r r s s o o l l v v e e n n t t s s . .
C C . . C C o o n n n n e e c c t t t t h h e e b b a a s s e e u u n n i i t t
!
1) Connect the AC adapter to the DC IN 9V jack and a standard
120V AC wall outlet.
2) Set the base on a desk or tabletop, and place the handset on
the base unit as shown. Remove the beltclip, if attached for
Place the power cord
face up charging. (For wall mounting, see "Mounting the Base
so that it does not
Unit on a Wall", on page 9 and 10).
create a trip hazard
or where it could
3) Raise the antenna to a ver tical position.
become chafed and
create a fire or
4) Make sure the status LED lights. If the LED does not light,
electrical hazard.
check to see that the AC adapter is plugged in and the
handset makes good contact with the base charging contacts.
Af ter installing the battery pack in the handset, c c h h a a r r g g e e y y o o u u r r h h a a n n d d s s e e t t a a t t
note
l l e e a a s s t t 1 1 5 5 - - 2 2 0 0 h h o o u u r r s s b b e e f f o o r r e e p p l l u u g g g g i i n n g g i i n n t t o o t t h h e e p p h h o o n n e e l l i i n n e e . Once the handset
battery pack is fully charged, connect the telephone line cord to the base
and telephone wall outlet.
•The handset can
• Use only the supplied AD-420 AC adapter. Do not use any other AC adapter.
note
be placed face up
• Connect the AC adapter to a continuous power supply.
or face down in
• Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.
the base for
5) Connect the telephone line cord to the TEL LINE 1 jack and a telephone outlet
charging.
once the handset is fully charged.
•You must remove
the beltclip, if
If your telephone outlet isn´t modular,
tip
attached, for face
contact your telephone company for assistance.
up charging.
[ 8 ]
G E T T I N G S T A R T E D
M M o o d d u u l l a a r r
Advertisement
Table of Contents
