Freestanding Installation - Follett Chewblet 7 Series Installation, Operation And Service Manual

Optional Leg Accessory Installation
CAUTION!
Use caution when tipping the dispenser during leg installation. Do
not lay unit on back or side. DO NOT EXCEED 30° angle. Tipping
more than 30° can result in compressor malfunction.
1. If installing optional 4" Leg Accessory (item# 00956300), place a
12.7 cm (5") spacer underneath the dispenser to ease installation.
2. Remove four plastic, thread-protecting plugs from bottom of
dispenser.
3. Screw each leg into chassis (Fig. 3).

Freestanding Installation

Installation instructions for countertop model may be found on
Installation on page 8.
1. A clearance of at least 3" (7.62 cm) is required behind and on
each side of the dispenser for electrical connection and ventilation
(Fig. 4).
2. Rough-in the electrical service and water line.
§ Electrical: 230V, single phase. The dispenser is provided with an
2.4 m (8 ft) power cord with choice of CEE 7/7, AS 3112, or BS 1363
plug.
§ Water: supply line (with shut-off valve) connects to the dispenser's
1/4" MPT inlet.
NOTICE!
If installing optional Leg Accessory, complete those steps before
proceeding. See page 11 for Leg Accessory instructions.
Countertop
Dispenser and Ice Machine 230 V/50 Hz and 220 V/60 Hz
Fig. 3
12.7 cm (5") spacer
min.
Fig. 4
freestanding models
minimum 3" (7.6 cm)
clearance required
9