Freestanding Installation - Follett 7CI100A Installation, Operation And Service Manual

Installation
(continued)
Optional Leg Accessory Installation
CAUTION!
Use caution when tipping the dispenser during leg installation. Do
not lay unit on back or side. DO NOT EXCEED 30° angle. Tipping
more than 30° can result in compressor malfunction.
1. If installing optional 4" Leg Accessory (item# 00956300), place a 5"
(127 mm) spacer underneath the dispenser to ease installation.
2. Remove four plastic, thread-protecting plugs from bottom of
dispenser.
3. Screw each leg into chassis (Fig. 3).

Freestanding Installation

Installation instructions for countertop model may be found on
Installation on page 6.
1. A clearance of at least 3" (77 mm) is required behind and on
each side of the dispenser for electrical connection and ventilation
(Fig. 1).
2. Rough-in the electrical service and water line.
§ Electrical: 115V, single phase, 15A receptacle required. The dispenser
has an integral 8 ft. (2.4 m) cord and plug.
§ Water: supply line (with shut-off valve) connects to the dispenser's 1/4"
MPT inlet.
NOTICE!
If using Leg Accessory with base stand, complete those steps
before proceeding.
8 Dispenser and Icemaker 7CI100A/7FS100A
–––––––––––––––––––––––––––––––––––––––––––––––––
Fig. 5
5" (127 mm)
min.
Fig. 6
Countertop
spacer
freestanding models
minimum 3" (77 mm)
clearance required