Selecting.the.base - Uniden DECT1580 User Manual

4) Wait.approximately.thirty.seconds..Registration complete.will.be.displayed.to.indicate.the.handset.has.been.
registered.to.the.base.and.a.handset.ID.will.be.automatically.assigned..The.handset.assigns.its.own.ID.to.this.
base,.too..(Since.the.base.ID.is.based.on.the.order.in.which.the.handset.was.registered.to.the.different.bases,.a.
base.may.have.different.IDs.on.each.handset.)
If.Registration failed.appears.in.the.LCD,.please.try.these.steps.again.
Note:. The.handset.will.stay.connected.to.the.new.base.until.you.select.a.different.base.(see.below).
Selecting the base
After.you.register.your.handset.to.more.than.one.base,.you.can.set.the.handset.to.automatically.search.for.a.new.
base.if.the.base.it's.currently.connected.is.unavailable.or.out.of.range..You.can.also.manually.select.which.base.you.
want.the.handset.to.connect.to;.for.example,.if.you.have.one.base.with.an.answering.machine,.you.can.connect.to.
that.base.to.check.messages.from.the.handset.
1) With.the.phone.in.standby,.press.MENU/SELECT..Select.the.Handset Setup.menu,.and.then.the.Select Base.
submenu.
) Move.the.cursor.to.select.the.base.you.want.to.connect.to,.or.choose.Auto.to.have.the.handset.automatically.
search.for.and.select.base.
3) Press.MENU/SELECT..Searching.will.appear.in.the.display.
4) When.the.base.is.found,.the.handset.will.return.to.standby..If.the.base.is.not.found,."Searching".continues.
to appear. You can repeat the procedure listed above to return back to the original connection or to find the
different.base.
Note:. You.cannot.change.bases.during.a.call..
15