Uniden DECT1580 User Manual page 51

To.operate.from.a.remote.location,.use.any.touch-tone.telephone,.and.follow.these.steps:
1) Call.your.telephone.number.and.wait.for.the.system.to.answer..If.the.answering.system.is.off,.it.will.answer.after.
about.ten.rings.and.sounds.a.series.of.beeps.
) During.the.greeting.or.the.beeps.(if.answering.system.is.off),.press.0.and.enter.your.security.code/PIN.within.
two.seconds.
3) The.answering.system.announces.the.current.time.and.the.number.of.messages.stored.in.memory..
You.hear."To.play.incoming.messages,.press.zero-two..For.help,.press.one-zero".followed.by.a.beep.
4) Enter a remote command from the chart below. You have fifteen seconds to enter the first command; after the
first command, you have two seconds to enter each command.
If you want to
Play.incoming.
messages
Repeat.this.message.
Go.back.to.the.
previous.message
Skip.this.message
Delete.this.message
5) When you finish, you will hear intermittent beeps indicating that the system is in the command waiting mode.
Enter another command from the chart within fifteen seconds.
6) Hang.up.to.exit.the.system..The.answering.system.automatically.returns.to.its.normal.standby.setting.
Press
0.then.2.
The.answering.system.plays.back.
messages.for.four.minutes,.then.
waits.for.another.command..To.
continue.playing.your.messages,.
press.0.then.2.again.
0.then.1 (after the first four
seconds.of.this.message)
0.then.1 during the first four
seconds.of.a.message.
0.then.3
0.then.4
If you want to
Stop.the.current.operation.to.
enter.a.different.command.
Turn.the.answering.system.off
Turn.the.answering.system.on
Listen.to.the.help.prompts
Exit.the.system
51
Press
0.then.5
0.then.9
0.then.6
1.then.0
Hang.up.