Cisco ASR 1002-F Overview And Installation page 9

Cisco ASR 1002-F Router Overview and Installation
Figure 9: DC Power Supply for the Cisco ASR 1002-F Router
1 Chassis ESD socket
2 DC power supply slot 0 label
3 DC power supply Standby/On (|) switch
4 DC power supply LEDs
5 Fan
The following table defines the Cisco ASR 1002-F Router DC power supply LEDs on the Cisco ASR 1002-F
Router.
Table 3: Cisco ASR 1002-F Router DC Power Supply LEDs
LED Label LED
INPUT OK Power supply
activity
FAN OK Power supply fan
status activity
OUTPUT Power supply
FAIL activity
The table shows the DC power supply output voltage alarm range.
Color Description
Green The DC power supply input voltage is greater than 43.5 VDC at turn-on and remains
green down to 39 VDC.
Amber The power supply turns off due to low input voltage (falls below 39VDC) and indicates
that there is still a hazard present (voltage on the terminal block). The LED remains
amber and is active to around 20 V +/-5 V.
Off The input is below 15V
Green All fans are operational.
Red A fan failure is detected.
Red The DC output is out of the specified range. When you turn the power supply on, the
red LED illuminates for two to three seconds to test LED operation before going off.
Off The DC output voltage are within the normal operating range.
DC Power Supply for the Cisco ASR 1002-F Router
6 Captive installation screw
7 DC power supply slot 1 label
8 Ground lead
9 Positive lead
1 0 Negative lead
Cisco ASR 1002-F Router Overview and Installation
9