Cisco ASR 1002-F Overview And Installation page 2

Front View
• An integrated 4xGE SPA interface
• Fixed 2.5 GB of system bandwidth and 4 GB DRAM
• A built-in 4x1GE SPA providing four small form-factor pluggable (SFP-based) GE connections, designated
For information about the SFP transceiver modules that are compatible with Cisco ASR 1002 Built-in Gigabit
Ethernet Ports (4x1GE), refer to the "Modular Optics Compatibility" section in Cisco ASR 1000 Series
Aggregation Services Routers SIP and SPA Hardware Installation Guide .
Note
Only Cisco software release four code supports the Cisco ASR 1002-F Router. Do not use earlier versions of
Cisco software.
This section contains the following topics:
Front View
Figure 1: Cisco ASR 1002-F Router—Front View, on page 2
Router with the Cisco ASR 1002-ESP-F, Cisco ASR 1000 route processor, and a SPA-4XOC12-POS installed.
Figure 1: Cisco ASR 1002-F Router Front View
1 Integrated Cisco ASR 1002-ESP-F
2 Integrated Cisco RP
Rear View
The following image shows the rear of the Cisco ASR 1002-F Router with AC power supplies installed.
Cisco ASR 1002-F Router Overview and Installation
2
as SPA bay 0
.
Cisco ASR 1002-F Router Overview and Installation
shows the front of the Cisco ASR 1002-F
3 Cisco ASR 1002-SIP10-F with a SPA installed
— —