Cisco ASR 1002-F Overview And Installation page 21

Cisco ASR 1002-F Router Overview and Installation
Figure 15: Installing the Cisco ASR 1002-F Router on a Two-Post Equipment Rack
1 Rack equipment rail
Step 2 Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on both sides of the
rack.
Step 3 Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the holes on the rack
or mounting strip.
Step 4 For each bracket, insert and tighten two screws to the rack on both sides.
What to do next
This completes the procedure for installing the chassis on a two-post rack. Proceed to the Attaching a Chassis
Ground Connection. to continue the installation.
Four-Post Rack Installation
The Cisco ASR 1002-F Router can be flush-mounted in a 19-inch equipment rack using the rack-mounting
kit provided with your system. When handling the chassis, always follow proper lifting practices. See the
"Chassis-Lifting Guidelines" section.
Note
Inner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches (48.26
cm). The height of the chassis is 3.47 inches (8.8 cm). Airflow through the chassis is from front to back.
2 Front rack-mount bracket ear and holes
Cisco ASR 1002-F Router Overview and Installation
Four-Post Rack Installation
21