Cisco ASR 1002-F Overview And Installation page 7

Cisco ASR 1002-F Router Overview and Installation
1 C/A (Carrier/Alarm)
2 A/L (Active/Loopback)
The following table describes the Cisco ASR 1002-F Router SPA LEDs.
Table 1: Cisco ASR 1002-F Router SPA LEDs
LED
Label
C/A
A/L
STATUS
Cisco Integrated ASR 1002-SIP10-F and SPA for Cisco ASR 1002-F Router
Description
The Cisco ASR 1002-SIP10-F in the Cisco ASR 1002-F Router is integrated into the chassis and you cannot
insert or remove it. The Cisco integrated ASR 1002-SIP10-F provides the physical and electrical termination
for one half-height SPA.
The Cisco integrated ASR 1002-SIP10-F interface supports all Cisco SPA interface processor functions and
services. However, the Cisco integrated ASR 1002-SIP10-F differs in the following areas:
• Functions as the base board for the Cisco integrated RP
• Is not a field-replaceable unit (FRU) and does not support online insertion and removal (OIR)
Power Supplies in the Cisco ASR 1002-F Router
The Cisco ASR 1002-F Router power supply consists of either an AC or DC input in a closed frame power
supply with two DC voltage outputs: 12 V and 3.3 V. The AC power supply operates between 85 VAC to
264 VAC and the DC power supply operates between –40.5 VDC to –72 VDC.
Cisco Integrated ASR 1002-SIP10-F and SPA for Cisco ASR 1002-F Router Description
3 SPA
STATUS
— —
Color State Meaning
Off Off SONET alarm controller is shut down.
Green On Port is enabled by software and there is a valid SONET alarm signal without any
alarms.
Amber On Port is enabled by software and there is at least one alarm.
Off Off Interface is shut down.
Green On Port is enabled by software and loopback is off.
Amber On Port is enabled by software and loopback is on.
Off Off SPA power is off.
Green On SPA is ready and operational.
Amber On SPA power is on and good and the SPA is being configured.
Cisco ASR 1002-F Router Overview and Installation
7