Attaching The Chassis Rack-Mount Brackets - Cisco ASR 1002-F Overview And Installation

Attaching the Chassis Rack-Mount Brackets

Figure 12: Verifying Equipment Rack Dimensions
Attaching the Chassis Rack-Mount Brackets
This section explains how to attach the front and rear rack-mount brackets to the chassis. Before installing
the chassis in the rack, you must install the rack-mount brackets on each side of the chassis.
The parts and tools required for installing the rack-mount brackets and cable-management brackets are listed
in the "Tools and Equipment" section on page 5-23 .
Note The cable-management brackets are attached to the chassis after you install the chassis rack-mount brackets
on the chassis and mount the chassis in the rack.
Chassis Front Rack-Mount Brackets
Determine where in the rack you want the chassis to be mounted. If you are mounting more than one chassis
in the rack, then start from the bottom up or the center of the rack.
To install the front rack-mount brackets on the Cisco ASR 1002-F Router, perform the following steps:
SUMMARY STEPS
1. Locate the threaded holes on the side of the chassis. Make certain that you hold the front rack-mount
bracket with the ear and holes facing outward and towards the front of the chassis.
2. Position the front rack-mount bracket top hole with the chassis first top hole behind the side vent holes.
3. Insert and tighten the black screws on one side.
4. Repeat Step 1 through Step 3 on the other side of the chassis. Use the black screws to secure the rack-mount
brackets to the chassis.
5. Install the chassis in a rack. To install the Cisco ASR 1002-F Router in a rack, go to the
Cisco ASR 1002-F Router in a
Cisco ASR 1002-F Router Overview and Installation
16
Rack.
Cisco ASR 1002-F Router Overview and Installation
Installing the