Motor Does Not Run - Amana Speed Queen AWM190W2 Service Manual

40. MOTOR DOES NOT RUN
.
.
:
Electrical power off, fuse blown, or power cord not
plugged in.
Loading door not closed or inoperative switch.
Timer improperly set.
Inoperative timer.
Motor starting functions inoperative. No start;
or motor hums only.
Motor is dead, won't run.
Motor overload protector hB
0
cycled.
Bind in upper or lower motor bearing.
Broken, loose, or incorrect wiring.
Power cord is miswired.
63
TO CORRECT
Check laundry room for blown or loose fuse(s) or
open circuit breakers. (Washer itself does not have an
electrical fuse).
Close door or test switch and replace if inoperative.
Reset timer, or try another cycle.
Test timer and replace if inoperative.
Refer to SECTION V to check start switch and start
windings.
Refer to SECTION V to check switch and windings.
Wait two or three minutes for overload protector tr
reset. If protector cycles repeatedly, refer to
paragraph 43.
Remove belts and determine if motor shaft .viii spin.
Replace motor if shaft is locked up.
Refer to appropriate wiring diagram.
Refer to appropriate wiring diagram for correct
wiring.
RS3100002 (37400R3)
Rev.3