Pressure Switch; Belt (Agitate And 3Pin) - Amana Speed Queen AWM190W2 Service Manual

32. PRESSURE SWITCH (Refer to
Figure 49)
NOTE: DO NOT ADJUST PRESSURE SWITCH IF
WASHER IS WITHIN THE WARRANTY PERIOD.
Pressure switch is set at the factory for proper
water fill levels. However, if there is a problem of
overfilling or underfilling, pressure switch can be
adjusted.
Maximum water fill level can be increased by
turning adjusting screw CLOCKWISE, and
decreased by turning screw
COUNTERCLOCKWISE.
One quarter turn of the adjusting screw
represents approximately one inch (25.4 mm)
increase or decrease of water level in washtub.
IMPORTANT: DO NOT turn adjusting screw more
than 3/4 of a turn in either direction as the switch
may be damaged and flooding could result.
33. BELT (Agitate and Spin)
No belt adjustment is required.
RS3100002 (37400R3)
Rev. 3
58
Fixed Pressure Switch
..DJUSTING
SCREW
Rotary Pressure Switch
ADJUSTING
SCREW
Figure 49
W275SE1A