Cabinet Top Assembly - Amana Speed Queen AWM190W2 Service Manual

A
WARNING~~~~~~~~~~~~~~~~~~~~~~~~~~
o'~tlae rlakfl:;l"~trif:)@p,~·fl,., expk)llJ~
..t;.11.111Jury
or~·······•
·
a-"lflCt
elec~power:~tlje washer~
"""°'119· • <lie ·
ever~~=-•1Pc'!.9'J:,a;r:=;:;.
•.
grourid~l~:il,.,.
-
•recowcted
to~~
that the W:nher
I• properly
tl~ed.
:
ii,k;,;.,:;
l'/003
'W
18. CABINET TOP ASSEMBLY
a. Remove two screws from bottom edge of front
panel, Figure 25.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of panel)
disengage from slots in cabinet top, Figure 25.
c. Remove two cabinet top hold-down screws,
Figure 25.
d. If area or space permits, tape loading door
closed and lift cabinet top to a vertical position
by hinging it on the rear hold-down bracket.
NOTE: Cabinet top is self-supporting, however, a
small chain may be used for additional support,
Figure26.
IMPORTANT: Before lowering cabinet top into
position, pivot outer tub forward far enough to
prevent damaging (bending) the out-of-balance
switch lever, Figure 28.
TO REMOVE CABINET TOP FROM WASHER
a. Repeat steps "a", "b" and "c" above.
b. Remove six screws (3 on top and 3 at lower
front) holding hood assembly to control hood
rear panel and cabinet top, Figure 27.
c. Disconnect hose from pressure switch and
push hose down through hole in cabinet top.
d. Disconnect wire harness at disconnect
blocks.
e. Reinstall control hood assembly.
f. Tape loading door closed.
g. Lift front of cabinet top slightly and pull
forward to disengage from rear hold-down
brackets.
h. Pull top forward far enough to permit
disconnecting ground wires from top left rear
corner gusset of washer cabinet, Figure 28.
i. Disconnect wires from mixing valve solenoids
at quick disconnect blocks, Figure 28.
RS3100002 (374-00R3)
Rev.3
24
NOTE: Refer to appropriate wiring diagram when
rewiring mixing valve solenoids.
j.
Carefully lift cabinet top off washer and set
alongside the washer cabinet on protective
padding.
IMPORTANT: DO NOT lay cabinet top flat because
it will damage door switch actuator arm or out-of-
balance lever. When reinstalling cabinet top and
before lowering top into position, pivot outer tub
forward far enough to prevent damaging
(bending) the out-of-balance switch lever.
I
.
:
~0z----~e
_ _ _ _
~o":il:' W214SEtA
Figure 26