Sony HDCU5000 Operating Instructions Manual page 81

NETWORK
Page name Item
Page No.
<SNMP> SNMP
N15
PORT
NAME
CONTACT
LOCATION
V1
V2C
V1/V2C
<SNMP TRAP> SNMP TRAP
N16
COMMUNITY
HOST1
HOST2
HOST3
SEND TEST TRAP
Set value
ENABLE, DISABLE
LAN-COM
ENABLE ENABLE, DISABLE
ENABLE ENABLE, DISABLE
RO COMMUNITY sony
ALLOW HOST ANY, SPECIFIC
HOST1 IP 0.0.0.0 to 255.255.255.255
ADDRESS
HOST2 IP
ADDRESS
HOST3 IP
ADDRESS
ENABLE, DISABLE
IP ADDRESS 0.0.0.0 to 255.255.255.255
VERSION V1, V2C
EXEC
Description
Enables/disables SNMP.
Note
Can be enabled by installing HZCU-SNMP50 SNMP
Agent Software (option).
Displays the connection port name.
Displays the system name (ASCII code, up to 32
characters).
Displays the system administrator's name (ASCII
code, up to 32 characters).
Displays the system installation location (ASCII
code, up to 32 characters).
Enables/disables SNMP V1.
Enables/disables SNMP V2C.
Displays the ReadOnly community name (ASCII
code, up to 32 characters).
Sets the hosts that can be connected.
ANY: Allow access from all IP addresses.
SPECIFIC: Allow access only from IP addresses
configured using the HOST IP ADDRESS items.
Sets the address of a host that can connect with
access permission when ALLOW HOST is set to
SPECIFIC.
Enables/disables SNMP traps.
Selectable when SNMP is enabled. Fixed to
DISABLE when SNMP is disabled.
Displays the trap community name (ASCII code, up
to 32 characters).
Sets the trap notification address.
Sets the trap version.
Same setting items and values as HOST1.
Same setting items and values as HOST1.
Sends a test trap.
81