Removal And Replacement Of Pump Motor - Hoshizaki KM-150BAF Service Manual

7) Remove the Fitting and the Gasket.
8) Release the Hose Clamp, and disconnect the Hose.
9) Remove the Water Valve from the Rear Panel.
10) Install the new Water Valve, and replace the removed parts in the reverse order of
which they were removed.
11) Replace the Top Panel in its correct position.
12) Open the Water Supply Line Shut-off Valve.
13) Plug in the icemaker, and turn on the power supply.

13. REMOVAL AND REPLACEMENT OF PUMP MOTOR

Note: When replacing a Pump Motor with defective winding, it is recommended that a
new capacitor be installed.
1) Turn off the power supply, and unplug the icemaker.
2) Remove the Top Panel and Rear Panel.
3) Open the Bin Door.
4) Drain the Water Tank by removing the Rubber Tube and thumbscrew and pulling the
Tank forward and slightly down.
5) Release the Hose Clamp, and disconnect the Hose from the Spray Tube.
6) Remove the closed end connectors of the Pump Motor leads.
7) Remove the screw and the Pump Motor Bracket.
8) Lift up the Pump Motor with the Pump Motor Bracket.
9) Release the Hose Clamp, and disconnect the Hose for the Cleaning Water Valve.
10) Remove the four screws and the Pump Motor.
11) Install the new Pump Motor, and replace the removed parts in the reverse order of which
they were removed.
48