Removal And Replacement Of Water Valves; Removal And Replacement Of Pump Motor - Hoshizaki KML-351MAH Service Manual

3) Remove the junction box cover from the remote condenser unit (remote air-cooled
model).
4) Disconnect the fan motor wires.
5) Remove the fan motor bracket and fan motor.
6) Install the new fan motor, connect the fan motor wires, and replace the removed parts
in the reverse order of which they were removed.
7) Replace the panels in their correct positions.
8) Replace the junction box cover in its correct position (remote air-cooled model).
9) Turn on the power supply.
L. Removal and Replacement of Water Valves
1) Turn off the power supply.
2) Close the icemaker water supply line shut-off valve. Open the icemaker water supply
line drain valve.
3) Remove the panels.
4) Remove the tubing attached to the valve. If replacing the inlet water valve, loosen the
fitting nut. Be careful not to lose the washer.
5) Disconnect the terminals from the valve.
6) Remove the bracket and valve from the unit.
7) Install the new valve. Replace the removed parts in the reverse order of which they
were removed. If replacing the inlet water valve, make sure the washer is in place in the
fitting nut.
8) Close the icemaker water supply line drain valve. Open the icemaker water supply line
shut-off valve.
9) Turn on the power supply.
10) Check for leaks.
11) Replace the panels in their correct positions.
M. Removal and Replacement of Pump Motor
1) Turn off the power supply.
2) Remove the front panel.
3) Remove the three screws and the float switch assembly.
4) Disconnect the pump motor wiring connector and the ground wire.
5) Disconnect the hoses attached to the pump motor assembly.
6) Remove the four screws and the pump motor.
7) Install the new pump, and replace the removed parts in the reverse order of which they
were removed. Be sure to connect the ground wire.
8) Turn on the power supply, and check for leaks.
9) Replace the front panel in its correct position.
51